SAM
®
RF Operations Manual 91
Section 5: Keys
© SAFLOK WL 12/20/2007
Creating Additional Construction Keys (continued)
7. At the Create Construction Key PC dialog
box, the name of the person you selected
will appear. Place a key in the electronic
key encoder now and click OK.
Note: You must keep the key in the electronic key encoder base while the key image spins on the PC
screen.
8. The PC dialog box will display, “The write operation was successful!” The key is now encoded. Click
OK, and then remove the key from the electronic key encoder base.
9. The screen will return to the Create Construction Key PC dialog box. If you wish to create additional
construction keys, click the button to the right of the box. (This button has a hand pointing to the
right.) Follow the procedures previously described.
Note: It is recommended that you limit the number of Construction keys to only those individuals who
absolutely need keys. The use of Construction keys are not stored in the lock’s memory. When locks are
in the construction mode, they cannot be audited.
To Next Page
Loading...