KEB COMBIVERT F5 Servo User Manual

1 1
Name: Basis
KEB COMBIVERT F5-M / S
10
18.05.04
Introduction
General
© KEB Antriebstechnik, 2002
All Rights reserved
Chapter Section Page Date
6.5.2 Rated frequency (uF.0) and Boost (uF.1) ............................. 6.5.4
6.5.3 Additional Rated Point (uF.2/uF.3) ....................................... 6.5.4
6.5.4 Delta Boost (uF.4/uF.5) ........................................................ 6.5.4
6.5.5 Voltage Stabilization (uF.9).................................................. 6.5.5
6.5.6 Maximal voltage mode (uF.10)............................................. 6.5.6
6.5.7 Switching Frequency (uF.11) ............................................... 6.5.6
6.5.8 Used Parameters................................................................. 6.5.7
6.6 Motor Data and Controller ................................................................. 6.6.3
6.6.1 Motor Name Plate................................................................ 6.6.3
6.6.2 Motor Data DASM................................................................ 6.6.3
6.6.3 Motor Adaption (Fr.10) ......................................................... 6.6.6
6.6.4 Torque Limitation ................................................................. 6.6.7
6.6.5 Flux Lowering Calculation................................................... 6.6.8
6.6.6 Motor Data DSM.................................................................. 6.6.9
6.6.7 Motor Data Parameter ....................................................... 6.6.10
6.6.8 Controller Structure ........................................................... 6.6.11
6.6.9 Current Control (Torque Control) .......................................6.6.12
6.6.10 Flux / Rotor Adaption......................................................... 6.6.13
6.6.11 Speed Control ................................................................... 6.6.14
6.6.12 Torque Control...................................................................6.6.15
6.6.13 Used Parameters...............................................................6.6.16
6.7 Protective Functions.......................................................................... 6.7.3
6.7.1 Ramp Stop and Hardware Current Limit.............................. 6.7.3
6.7.2 Current Limit Constant Run (Stall-Function)........................ 6.7.5
6.7.3 Automatic Restart and Speed Search ................................. 6.7.7
6.7.4 Dead Time Compensation uF.18 ......................................... 6.7.9
6.7.5 Base-Block Time (uF.12) and Voltage Level (uF.13) ............ 6.7.9
6.7.6 Response to Errors or Warning Signals............................... 6.7.9
6.7.7 Quick Stop (Pn.58...60) .....................................................6.7.13
6.7.8 Motor Protection Mode ...................................................... 6.7.15
6.7.9 GTR7-Control.................................................................... 6.7.19
6.7.10 Special Functions..............................................................6.7.20
6.8 Parameter Sets ................................................................................... 6.8.3
6.8.1 Not Programmable Parameters ........................................... 6.8.3
6.8.2 Security-Parameters ............................................................ 6.8.3
6.8.3 System-Parameters ............................................................. 6.8.3
6.8.4 Indirect and Direct Set Addressing ...................................... 6.8.3
6.8.5 Copying of Parameter Sets via Keyboard (Fr.1) ................... 6.8.4
6.8.6 Copying of Parameter Sets via Bus (Fr.1, Fr.9) .................... 6.8.4
6.8.7 Parameter Set Selection...................................................... 6.8.5
6.8.8 Locking of Parameter Sets................................................... 6.8.8
6.8.9 Parameter Set ON/Off Delay (Fr.5, Fr.6) ............................... 6.8.8
6.8.10 Used Parameters................................................................. 6.8.9
6.9 Special Functions .............................................................................. 6.9.3
6.9.1 DC-Braking ......................................................................... 6.9.3
6.9.2 Energy Saving Function ...................................................... 6.9.5
6.9.3 Motor Potentiometer Function.............................................. 6.9.7

KEB COMBIVERT F5 Servo Specifications

General

Brand	KEB
Model	COMBIVERT F5 Servo
Category	DC Drives
Language	English