KEB combivert R6-S - Start-Up; Installation and Connection

Start-up
© KEB, 2008-02 COMBIVERT R6-S Page 4.1 - 3
4
10
4. Start-up
The following chapter is intended for everybody who has no experience with the KEB power supply and rege-
nerativeunits.Itshallallowacorrectenteringintothiseld.Butbecauseofthecomplexapplicationpossibilities
we must restrict ourselves to explaining the start-up of standard applications.
4.1 Preparatory measures
4.1.1 After unpacking the goods
Afterunpackingthegoodsandcheckingthemforcompletedeliveryfollowingmeasuresaretobecarriedout:

Visual control for transport damage
Should any external damages to the KEB COMBIVERT be visible get in tough with your forwarding agent
and return the unit with a corresponding report to KEB.
4.1.2 Installation and connection
Installation and connection instructions as well as EMC conform installation are found in the instruction manu-
al.
a.) Galvanized surface
b.) The mounting surface of the inverter must be bright.

If necessary, use contact lacquer as protection against corrosion

Connect the earthing strip to central point in the control cabinet
Installation and connection
4.1.3 Checklist prior to start-up