KEB combivert R6-S Applications Manual

Hardware
© KEB, 2008-02 COMBIVERT R6-S Seite 1.3 - 5
1
10
1.3.1.3 Control terminal strip X2A
X2A
           
       
Core cross-section 0,14…1,5 mm², tightening torque 0,5 Nm
PIN Function Name Description Specication
10 24 V DC input Uin external supply of the control board 23…30 V DC / 1A
11 Mass COM Reference potential
12 Digital input 1 ST Control release / Reset
Ri:4,4kΩ
13 Digital input 2 I1 programmable
14 Digital input 3 I2 programmable
15 Digital input 4 I3 programmable
16 Digital in-/output I/O (I4)
Active signal (connection of all R6 at paral-
lel operation in master-slave procedure)
17 24V output Uout Voltage supply for in- and outputs
ca. 24 V / max.
100 mA
18 Mass COM Reference potential
19 Digital output 1 O1 Transistor output (DC > CP.19) I
max:25mA
20 Digital output 2 O2 Transistor output (error message) I
max:25mA
21 Analog output / gain ANOUT
Difference between actual supply frequen-
cy and set supply frequency
1 V pro 0,1 Hz
Difference
22 24V output Uout see terminal 17
23 Mass COM Reference potential
24 Relay 1 / NO RLA
Relay output
Ready signal (no error)
max. 30 V DC *)
0,01…2 A DC
25 Relay 1 / NC RLB
26
Relay 1 / switching
contact
RLC
27 Relay 2 / NO FLA
Relay output
(DC > CP.19 and tightened load-shunt)
max. 30 V DC *)
0,01…2 A DC
28 Relay 2 / NC FLB
29
Relay 2 / switching
contact
FLC
*) The relay outputs must be operated with max. 48 V DC protective separation voltage to guarantee the CE
standard. After consultation KEB a current of max. 1 A DC is permissible for 120 V AC.

KEB combivert R6-S Specifications

General

Brand	KEB
Model	combivert R6-S
Category	Power Supply
Language	English