KEB combivert R6-S - Power Circuit Terminal Connections

Fundamentals
© KEB, 2008-02 COMBIVERT R6-S Page 2.1 - 3
2
10
Each parameter is well-
specied
2. Operation
Thefundamentalsofthesoftwareconguration,aswellastheoperationoftheunitaredescribedinthepresent
chapter.
2.1 Fundamentals
ThecontrolboardsR6containthefollowingoperationmodes:
Operation modes of the control board
Customer mode Application mode
- isafreelydenablelistofparameters(CP-Para-
meters), which are necessary or important for the
end user
- deliveredconditionwithaparameterlistdened
by KEB
- allparameters,parametergroups(exception:CP-
Parameters) and parameter sets can be selected
and changed if necessary
- is generally activated only for application adapti-
on
2.1.1 Parameters, parameter groups, parameter sets
What are parameters, parameter groups and parameter sets?
Parametersarevalueschangeablebytheuserinaprogram,whichaffecttheprogramow.Aparametercon-
sists of
Parameter designation Parameter value
The parameter value indicates the actual adjustment.
The parameter number determines the parameter
within a group.
All parameters are listed function-related in parameter
groups in order that the operation remains clear despite
of the multitude of parameters.
There are 8 parameter sets (0...7) in order to preset se-
veral values for a parameter.If the respective active values
shall be indicated during operation, set the digit to „A “.
The digit is not applicable at set-programmable parame-
ters.