13-2 Performance Verification
Introduction
NOTE Unless otherwise noted, Model 2306 refers to Models 2306, 2306-PJ, 2306-VS, 2302,
and 2302-PJ while Model 2306 (only) refers to the specific Model 2306 (not 2306-PJ,
etc.). Other Model numbers refer specifically to their respective models.
Use the procedures in this section to verify that Model 2306 accuracy is within the limits
sta
ted in the accuracy specifications. You can perform these verification procedures:
• When you first receive the unit to make sure that it was not damaged during shipment.
• To verify that the unit meets factory specifications.
• To determine if calibration is required.
• Following calibration to make sure it was performed properly.
WARNING The information in this section is intended only for qualified service personnel.
Do not
attempt these procedures unless you are qualified to do so.
NOTE If the unit is still under warranty, and its performance is outside specified limits,
contac
t your Keithley representative or the factory to determine the correct course of
action.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
