8 Status Structure
Table 8-1 Common and SCPI commands — reset registers and clear queues ................... 8-4
Table 8-2 Command commands — status byte and s
ervice request enable registers ........ 8-9
Table 8-3 Common and SCPI commands — condition re
gisters ..................................... 8-17
Table 8-4 Common and SCPI commands — event re
gisters ........................................... 8-17
Table 8-5 Common and SCPI commands — event enable re
gisters ................................ 8-18
Table 8-6 SCPI commands — error queue .
...................................................................... 8-21
9 Common Commands
Table 9-1 IEEE-488.2 common commands and queries .................................................... 9-2
Table 9-2 *OPC and *OPC? commands ............................................................................ 9-4
10 Signal Oriented Measurement Commands
Table 10-1 Signal oriented measurement command summary .......................................... 10-2
11 DISPlay, FORMat, and SYSTem
Table 11-1 SCPI commands — display ............................................................................. 11-2
Table 11-2 SCPI commands — data format ....................................................................... 11-4
Table 11-3 SCPI commands — system .............................................................................. 11-7
12 SCPI Tables
Table 12-1 Display command summary (refer to Display subsystem in Section 11) ........ 12-3
Table 12-2 FORMat command summary
(refer to Format subsystem in Section 11) ....... 12-4
Table 12-3 OUTPut command summary (r
efer to Tables 2-3 and 5-2) ............................. 12-5
Table 12-4 SENSe command summary (refer to T
ables 2-3, 3-2, and 4-2) ....................... 12-6
Table 12-5 SOURce command summary (refer to Table 2-3) ......................................... 12-16
Table 12-6 STATus command summary (refer to Section 8) ........................................... 12-17
Table 12-7 SYSTem command summary (refer to Sys
tem subsystem in Section 11) ..... 12-19
Table 12-8 Model 2306-VS external trigger command summary (refer to Section 6) .... 12-20
13 Performance Verification
Table 13-1 Recommended verification equipment ............................................................. 13-4
Table 13-2 Output voltage accuracy limits .........................................................................
13-7
Table 13-3 Voltage readback accuracy limits .....................................................................
13-8
Table 13-4 Compliance current accuracy limits ...............................................................
13-10
Table 13-5 5A range current readback accuracy limits ....................................................
13-11
Table 13-6 5mA range current readback a
ccuracy limits ................................................. 13-13
Table 13-7 500mA range current readback accuracy limits
............................................. 13-15
Table 13-8 Digital voltmeter input accurac
y limits .......................................................... 13-17
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
