Getting Started 1-3
Inspection
The power supply was carefully inspected electrically and mechanically before shipment.
After unpacking all items from the shipping carton, check for any obvious signs of physical
damage that may have occurred during transit. (Note: There may be a protective film over the
display lens, which can be removed.) Report any damage to the shipping agent immediately.
Save the original packing carton for possible future shipment. The following items are included
with every order:
• Model 2306 Dual Channel Battery/Charger Simulator with line cord
• Quick Disconnect Output/DVM Input Connector (2)
• Accessories as ordered
• Certificate of calibration
• Product Information CD-ROM that contains PDFs of Model 2302/2306 Instruction
Ma
nual and Model 2302/2306 Quick Results Guide
• Model 2302/2306 Quick Results Guide (Hardcopy)
• Model 2306-VS External Trigger Functionality Flowchart (Hardcopy)
If an additional manual is required, order the manual pac
kage. The manual package includes
a manual and any pertinent addenda.
Any improvements or changes concerning the instrument or manual will be explained in an
adde
ndum included with the manual. Be sure to note these changes and incorporate them into
the manual.
Options and accessories
The following options and accessories are available for the power supply.
• 2304-DISP and 2306-DISP remote display unit (2304-DISP cannot be used with the
Mo
del 2306-VS, use the 2306-DISP instead)
• Shielded IEEE-488 cable, 1m (3.3 ft) (P/N 7007-1)
• Shielded IEEE-488 cable, 2m (6.6 ft) (P/N 7007-2)
• Single fixed rack mount kit (P/N 4288-1)
• Dual fixed rack mount kit (P/N 4288-2)
• IEEE-488 Interface/controller for the PCI bus (P/N KPCI-488)
• IEEE Interface card for IBM PC/AT (full slot) (P/N KPC-488-2AT)
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
