To Next Page

To Previous Page

1-14 Getting Started

Setups — Save, Power-on, and Recall

Setups are configured by SAVE SETUP, POWER ON SETUP and RECALL SETUP items

of the MENU (which is accessed by pressing the MENU key). When a setup is saved, all settings

that are channel specific settings will be saved to that setup. Saving/recalling a setup has no

effect on Global Settings (see Global settings in Table 1-2 on page 1-12.) Similarly, recalling a

setup loads only the channel specific parameters from that setup.

NOTE T

able 1-3 shows the menu structure. Rules to navigate the menu follow the table.

The setup MENU items are explained as follows:

NOTE F

or the Models 2306-PJ and 2306-VS, the memory location settings available are

from SAV0-SAV2 (SAV3 and SAV4 are not available).

• SA

VE SETUP - Save the present power supply setup to a memory location;

SAV0-SAV4.

• RE

CALL SETUP - Return the power supply to the RST defaults (Table 1-2 on page

1-12), or to one of the user saved setups; SAV0-SAV4. Note the operate state (output) is

always recalled as OFF.

• POWER-ON SETUP - Se

lect the setup to use at power-up; RST, SAV0-SAV4 (output

off).

When powering up to the SAV0, SAV1, SAV2, SAV3, or SAV4 setup, the output will be OFF

gardless of the operate state when the setup was saved. For example, if the output is ON when

the setup is saved as SAV0, the power supply will power up with the output OFF for the SAV0

power-on setup.

NOTE F

or GPIB operation, the setups are saved and recalled using the *SAV, *RCL, and

*RST commands. (See Section 9 for details.) The power-on setup is selected using the

SYSTem:POSetup command (Section 11).

Many aspects of operation are configured from the menus summarized in Table 1-3. Use the

rules following the table to navigate through the menu structure.

NOTE The menu k

ey is used to access the menu structure. However, if in remote for IEEE-

488 bus operation (“R” displayed below “ON/OFF”) the menu key returns the

instrument to LOCAL operation.

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

TestEquipmentDepot.com

Keithley 2302 User Manual

Other manuals for Keithley 2302