Getting Started 1-13
Setting
Reset (RST) default
Battery Channel (#1) Charger Channel (#2)
Step delay 0
Step range 5A
Step trigger level 0
Trigger External
(Mode
l 2306-VS)
Both NONE NONE
Input edge FALLING FALLING
Output edge FALLING FALLING
Enable OFF OFF
Step 1-20, 0V, 0S 1-20, 0V, 0S
Voltage step OFF OFF
End voltage 0V 0V
Reading AUTO AUTO
Points 1 1
VPT ON ON
Long integration:
Integration time 1 second 1 second
Pulse timeout 16 seconds 16 seconds
Trigger edge RISING RISING
Trigger level Same as “Trigger level” (above) Same as “Trigger level” (above)
**Global settings (not channel specific).
**Default is HIGH for firmware version B02 and lower.
Table 1-2 (cont.)
Factory defaults (RST)
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
