2-2 Basic Power Supply Operation
NOTES This manual covers Keithley Models 2302, 2302-PJ, 2306, 2306-PJ, and 2306-VS
simulators (power supplies). Since the Model 2302 and 2302-PJ are single channel
battery simulators, functions related to the second channel (i.e., the charger channel)
are not available for the Model 2302 and 2302-PJ. Therefore:
• battery and charger channel features contained in this manual apply for the
Model 2306, 2306-PJ, and 2306-VS
• only battery channel features contained in this manual apply for the Model 2302
and 2302-PJ
Refer to Appendix F for specific Model 2302 and 2302-PJ information.
Information contained in this section applies to all power supply channels (unless
otherwise noted). In this manual, channel 1 refers to the battery channel while chan-
nel 2 refers to the charger channel (2306, 2306-PJ, and 2306-VS feature only).
Test connections
WARNING When installing a unit into a test system, make sure the external power sources
do not apply voltage to the power supply in excess of its maximum limits (see
specifications). Failure to do so could result in personal injury or death.
WARNING The
source and measurement connections are provided with overvoltage
protection rated up to 500V for 50µs. Do not connect sources that produce
transient voltages greater than 500V or the protection provided by the
equipment may be degraded.
Test connections to the power supply are made at the rear panel using a quick disconnect
OUTPUT/D
VM IN connector (see rear panel in Figure 1-1 for connector location). Use up to
#14 AWG wire for the screw terminals of the connector. Once the connector is wired up, plug it
into the rear panel and tighten the captive retaining screws.
Figure 2-1 sho
ws four wire sense power supply connections to the DUT.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
