Contact information 1-3
Continuous power operating boundaries 8-10
Cooling vents 1-12
Current accuracy 15-10
Output 15-10, 15-12
Current measurement accuracy 15-14, 15-15
Current measurement accuracy limits 15-16
D
Data store
Commands 7-5
Front panel 7-2
Overview 7-2
Programming examples 7-12
Remote 7-5
DCL (device clear) 11-8
Default settings 1-23
Default setups 1-24
Differences, remote vs. local operation 2-50
Digital I/O port 10-2
+5V output 10-2
Bit weighting 10-6
Commands 10-7
Configuration 10-2, 10-4
Controlling I/O lines 10-5
Front panel control 10-6
Interlock 10-11
Lines 10-2
Output enable 10-3, 10-9
Output enable control 10-9
Programming examples 10-8
Remote operation 10-7
Digits 6-6, 6-7, 7-12, 7-13, 7-14
Remote programming 6-7
Display
Annunciators 1-9
Resolution 6-7
Display modes 1-15
Display operations
Adding menu entries 14-13
Character codes 14-7
Clearing 14-5
Cursor position 14-5
Deleting menu entries 14-14
Functions and attributes 14-2
Input prompting 14-9
Keycodes 14-16
Load test menu 14-13
LOCAL lockout 14-12
Measurement functions 14-3
Menu 14-9
Messages 14-4
Resolution 14-4
Running a test 14-14
Text messages 14-6
Triggering 14-15
User screen 14-3
DISPLAY PATTERNS test 17-4
Duty cycle 8-33
E
Editing 1-17
Compliance 1-17
Controls 1-17
Source 1-17
Environmental conditions 15-2, 16-2
Line power 16-2
Temperature and relative humidity 16-2
Warm-up period 16-2
Error
and status messages 11-9
Error and status messages 1-22
Error messages
Effects on scripts B-2
Summary B-2
Examples
Ohms programming example 4-21, 4-23,
4-26
Source-measure programming example
4-16
F
Factory scripts 2-49, 13-2
Firmware upgrade 13-35
Modifying 2-49
Running 2-49
Fall time 8-32
Features 1-2
Filter
Front panel control 6-12
Filters 6-12
Commands 6-15
Configuration menu 6-13
Configuring 6-12
Enabling 6-13
Front panel control 6-12
Programming example 6-15
Remote programming 6-15
Response time 6-12
Types of 6-12
Floating a SMU 3-16
Flow control (signal handshaking) 11-12
To Next Page
Loading...
Need help?
General
