X8 MIG WELDER 2.3 Installation
2.
Push in the new neck and turn the neck tightener half a turn clockwise to secure it. Make sure you push
the neck deep enough: When the neck is correctly inserted, the groove on the neck is completely hidden
under the neck tightener.
Note:
You can rotate the neck into different positions without loosening the neck tightener.
Changing gas nozzle (gas-cooled gun)
Screw the gas nozzle into its place.
OPERATING MANUAL | EN 67
©
KEMPPI | 2018-09-28
To Next Page
Loading...
Need help?
General
