Kemppi X8 MIG User Manual

X8 MIG WELDER 2.4 Operation
Figure 16: The minimum and maximum stoppers for WPS
If you adjust the wire feed speed or voltage to a level outside the WPS range, the parameter graph turns red
and a warning symbol appears on the display.
Note:
If you have installed WeldEye, it saves the data as unsuitable use, even if the welding job requires
such values.
Figure 17: Values outside the range specified by WPS
OPERATING MANUAL | EN 90
©
KEMPPI | 2018-09-28

Kemppi X8 MIG Specifications

General

Brand	Kemppi
Model	X8 MIG
Category	Welding System
Language	English