:SECurity
:IMMediate Clears all user memory and reboots the instrument.
:SET <block data> Get and set the instrument state
:TIME <hh>, <mm>, <ss> Sets the time of the system clock.
:VERSion? Returns the SCPI version that the instrument complies with.
TRIGger
:ACQuire
[:IMMediate] Generates an immediate trigger.
:CURRent
[:LEVel] <value> Sets the triggered level of the output.
:SLOPe POSitive|NEGative Sets the slope of the signal.
:INDices
[:DATA]? Returns the indices where triggers were captured.
:COUNt? Returns the number of triggers captured during the acquisition.
:SOURce <source> Selects the trigger source for the acquisition system: BUS |CURRent1 |EXTernal |PIN<1-7>
|TRANsient1 |VOLTage1
:TOUTput
[:ENABle] 0|OFF|1|ON Enables measurement triggers to be sent to a digital port pin.
:VOLTage
[:LEVel] <value> Sets the triggered level of the output.
:SLOPe POSitive|NEGative Sets the slope of the signal.
:ARB
:SOURce <source> Selects the trigger source for arbitrary waveforms: BUS |EXTernal |IMMediate |PIN<1-7>
:ELOG
[:IMMediate] Generates an immediate trigger.
:SOURce <source> Selects the trigger source for external data logging: BUS |EXTernal |IMMediate |PIN<1-7>
:TRANsient
[:IMMediate] Generates an immediate trigger.
:SOURce <source> Selects the trigger source for the transient system: BUS |EXTernal |IMMediate |PIN<1-7>
1 Quick Reference
32 Keysight RP7900 Series Operating and Service Guide
To Next Page
Loading...
Need help?
General
