2 Getting Started
68 Keysight 34980A Mainframe User’s Guide
8 To stop the measurements, press DMM (in the Measure key group).
During This Tutorial Example:
– You configured the internal DMM for ac voltage measurements,
– You started measurements, viewed continuous measurement results, and
stopped the measurements.
Since you didn't open or close any channels, no module or Analog Bus relays were
exercised in this example. The internal DMM acted as a stand-alone instrument
and measured whatever ac voltages happened to be present on the Analog Buses.
Pressing DMM (in the Measure key group) also allowed you to continuously
monitor measurements on the front panel.
To Next Page
Loading...
