Getting Started 2
Keysight 34980A Mainframe User’s Guide 71
10 Press the Channel key (in the Measure key group). Note that the key lights, the
required relays automatically close, and dc voltage measurements begin.
11 To stop the continuous measurements, press Channel again. Note that as you
press Channel, you will hear the relays automatically opening.
12 Using steps 1 through 6 on the previous page, set the following configuration
for Channel 1014 (for this example, don't change any other measurement
parameters):
– Channel: 1014
– Measurement Function: AC Volts
–Range: 1V
13 Press EXIT MENU to accept the new settings and retain all other parameters in
this menu.
To Next Page
Loading...
