38 Keysight M8194A 120 GSa/s Arbitrary Waveform Generator User Guide
3 M8194A Soft Front Panel
Tabs
The M8194A Soft Front Panel includes the following tabs to configure the
most important parameters of the M8194A module:
• Output tab - For details, see Output Tab on page 44.
• Clock/Sync tab - For details, see Clock/Sync Tab on page 47.
• Standard Waveform tab - For details, see Standard Waveform Tab on
page 49.
• Multi-Tone Waveform tab - For details, see Multi-Tone Waveform Tab
on page 57.
• Complex Modulated Waveform tab - For details, see Complex
Modulated Waveform Tab on page 65.
• Serial Data Waveform tab - For details, see Serial Data Waveform Tab
on page 76.
• Import Waveform tab - For details, see Import Waveform Tab on
page 85.
All these tabs are described in detail in the sections, that follow.
Run / Stop Button
The Run/Stop button is used to switch between Run and Program mode.
When pressed the waveform generation is started and the “Run” turns
green . When pressed again the output sends a zero-waveform
and the “Stop” turns red . Output voltage offset remains active as
long as output port is enabled.
To Next Page
Loading...
