50 Keysight M8194A 120 GSa/s Arbitrary Waveform Generator User Guide
3 M8194A Soft Front Panel
Figure 14 Standard Waveform tab
This Standard Waveform tab has the following controls:
Waveform Destination Section
• Channel
The independent check boxes allow to set the standard waveforms for
Channel 1, Channel 2, Channel 3, or Channel 4. By default, one of the
check box is always selected. When the ‘Send To Instrument’ button is
pressed, the waveform is sent to all channels
that are selected.
• Generate I/Q Data
If selected, baseband (I/Q) signals will be generated. The effect of this
control depends on the selected signal type. For Sinusoidal waves, the
resulting complex signal will be a single spectral line located at positive
To Next Page
Loading...
