OUTPut:PROTection:TEMPerature:MARGin? (@<chanlist>)
Returns the margin remaining before the over-temperature trips. The temperature margin is the
minimum difference between the internal temperature sensors and the fixed over-temperature trip
level. The margin is returned in degrees Celsius.
Parameter Typical Return
(none) <margin value>
Returns the temperature margin: OUTP:PROT:TEMP:MARG? (@1)
OUTPut:PROTection:WDOG[:STATe] 0|OFF|1|ON
OUTPut:PROTection:WDOG[:STATe]?
Enables/disables the I/O watchdog timer. When enabled, the output will be disabled if there is no I/O
activity on any remote interface within the time period specified by OUTput:PROTection:WDOG:DELay.
The output is latched off but the programmed output state is not changed.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0îorî1
Enables the watchdog timer protection: OUTP:PROT:WDOG ON
OUTPut:PROTection:WDOG:DELay <value>
OUTPut:PROTection:WDOG:DELay? [MIN|MAX,]
Sets the watchdog delay time. When the watchdog timer is enabled, the output is disabled if there is
no SCPI I/O activity on any remote interface (USB, LAN, GPIB) within the delay time. The watchdog
timer function is NOT reset by activity on the front panel - the output will still shut down after the time
period has elapsed. Programmed values can range from 1 to 3600 seconds in 1 second increments.
Parameter Typical Return
0 - 3600|MIN|MAX, *RST 60 <delay value>
Sets a watchdog delay of 600 seconds: OUTP:PROT:WDOG:DEL 600
OUTPut:RELay:POLarity NORMal|REVerse, (@<chanlist>)
OUTPut:RELay:POLarity? (@<chanlist>)
This command only applies to models N673xA. N674xA, N675xA, N676xA, and N677xA
with .
Sets the polarity of the output relays on power modules with polarity reversal relays installed (Option
760). Polarity reversal affects both the output and the sense terminals.
Normal causes the output polarity to be the same as the output connector labeling.
5 SCPI Programming Reference
270 Keysight N6700C Operating and Service Guide
To Next Page
Loading...
