Keysight N9000B - 4.1.1.1 Show System contents (Remote Query Only); 4.1.1.2 Computer System description (Remote Query Only); 4.1.2 Show Hardware; 4.1.3 Show LXI

4 System
4.1 System
Example
:SYST:SHOW SYST
4.1.1.1 Show System contents (Remote Query Only)
Returns the contents of the Show System screen (the entire contents, not just the
currently displayed page).
Remote
Command
:SYSTem:CONFigure[:SYSTem]?
Example
:SYST:CONF?
Notes The output is an IEEE Block format of the Show System contents. Each line is separated by a new-line
character
4.1.1.2 Computer System description (Remote Query Only)
Returns the Computer System description, which consists of the operating system
and patch level, as reported by operating system.
Remote Command
:SYSTem:CSYStem?
Example
:SYST:CSYS?
Notes Returns the Computer System name and service pack level
4.1.2 Show Hardware
Displays details of the installed hardware. This information can be used to
determine versions of hardware assemblies and field-programmable devices, in the
advent of future upgrades or potential repair needs.
The screen is divided into two groups: product descriptive information and hardware
information. The hardware information is listed in a table format.
Example
:SYST:SHOW HARD
4.1.3 Show LXI
Displays the product number, serial number, firmware revision, computer name, IP
address, Host ID, LXI Class, LXI Version, MAC Address, and the Auto-MDIX
Capability.
Example
:SYST:SHOW LXI
Vector Modulation Analyzer Mode User's &Programmer's Reference 1838