Keysight N9000B - Multi Channel Config; Input Channel IP address; Input Channel Instrument port; Lock

3 VMA Mode
3.2 Custom OFDM Measurement
Multi Channel Config
Lets you perform a detailed configuration of your component carriers, including
number of carriers, bandwidth, offset, integration bandwidth, and so on.
Multi Channel Config
Only available for the Modulation Analysis measurement. Enables you to configure
multiple channel receiver. Different hardware platforms have different parameters.
Input Channel IP address
Sets instrument IP address for channel configuration, “local” is used for current
instrument.
Remote Command
[:SENSe]:OFDM:MCHannel:IPADdress1|2 <String>
[:SENSe]:OFDM:MCHannel:IPADdress1|2?
Example
:OFDM:MCH:IPAD1 '192.168.1.2'
Preset Local
State Saved Yes
Backwards Compatibility
SCPI
[:SENSe]:OFDM:MIMO:IPADdress1|2
Input Channel Instrument port
Sets instrument port for channel configuration.
Remote Command
[:SENSe]:OFDM:MCHannel:IPADdress1|2:PORT <int>
[:SENSe]:OFDM:MCHannel:IPADdress1|2:PORT?
Example
:OFDM:MCH:IPAD1:PORT 3574
Dependencies Only visible on VXT platforms
Preset 3574
State Saved Yes
Backwards Compatibility
SCPI
[:SENSe]:OFDM:MIMO:IPADdress1|2:PORT
Lock
Locks the instrument and assigns to a channel in sequence.
Vector Modulation Analyzer Mode User's &Programmer's Reference 546