429
Features of your vehicle
Power windows (if equipped)
The ignition switch must be in the ON
position for power windows to oper-
ate.
Each door has a power window switch
that controls the door's window. The
driver has a power window lock switch
which can block the operation of the
rear passengers windows. The power
windows can be operated for approxi-
mately 10 minutes after the ignition
key is removed or turned to the ACC
or LOCK position. However, if the
front doors open, the power windows
cannot be operated within the 30 sec-
ond period after ignition key removal
(if equipped).
If the window cannot be closed
because it is blocked by objects,
remove the objects and close the
window.
NOTICE
Whilst driving with the rear windows
down or with the sunroof (if
equipped) in an open (or partially
open position), your vehicle may
demonstrate a wind buffeting or
pulsation noise. This noise is a nor-
mal occurrence and can be reduced
or eliminated by taking the following
actions. If the noise occurs with one
or both of the rear windows down,
partially lower both front windows
approximately one inch. If you expe-
rience the noise with the sunroof
open, slightly reduce the size of the
sunroof opening.
Window opening and closing
The driver’s door has a master power
window switch that controls all the
windows in the vehicle.
To open or close a window, press
down or pull up the front portion of
the corresponding switch to the first
detent position (5).
OBD048084R
WARNING
Do not install any accessories
in the area of windows. It may
impact jam protection.
To Next Page
Loading...
