4135
Features of your vehicle
Windscreen washers
In the OFF (O) position, pull the lever
gently toward you to spray washer
fluid on the windscreen and to run
the wipers 1-3 cycles.
Use this function when the wind-
screen is dirty.
The spray and wiper operation will
continue until you release the lever.
If the washer does not work, check
the washer fluid level. If the fluid level
is not sufficient, you will need to add
appropriate non-abrasive wind-
screen washer fluid to the washer
reservoir.
CAUTION
• When washing the vehicle, set
the wiper switch in the OFF
(O) position to stop the auto
wiper operation.
The wiper may operate and be
damaged if the switch is set in
the AUTO mode whilst wash-
ing the vehicle.
• Do not remove the sensor
cover located on the upper
end of the driver side wind-
screen glass. Damage to sys-
tem parts could occur and
may not be covered by your
vehicle warranty.
• When starting the vehicle in
winter, set the wiper switch in
the OFF (O) position.
Otherwise, wipers may oper-
ate and ice may damage the
windscreen wiper blades.
Always remove all snow and
ice and defrost the wind-
screen properly prior to oper-
ating the windscreen wipers.
(Continued)
(Continued)
• When tinting the windscreen,
be careful of any fluid getting
into the sensor located in the
top centre of the front wind-
screen. It may damage the
related parts.
OCD048020
To Next Page
Loading...
