329
Safety features of your vehicle
To release the seat belt:
The seat belt is released by pressing
the release button (A) on the locking
buckle. When it is released, the belt
should automatically draw back into
the retractor.
If this does not happen, check the
belt to be sure it is not twisted, then
try again.
Stowing the rear seat belt
The rear seat belt buckles can be
stowed in the pocket between the
rear seatback and cushion when not
in use.
Pre-tensioner seat belt
(if equipped)
Your vehicle is equipped with pre-
tensioner seatbelts at the front and
rear outboard seating positions.
The purpose of the pre-tensioner is
to make sure that the seat belts fit
tightly against the occupant's body in
certain collisions.
The pre-tensioner seat belts may be
activated in crashes where the colli-
sion is severe enough.
OCD038028
ODE036087R
OUM036100R
To Next Page
Loading...
