6167
Driving your vehicle
Detecting sensor
The sensors are located inside the
rear bumper.
Always keep the rear bumper clean
for the system to work properly.
(Continued)
• The Blind-Spot Collision
Warning system (BCW) and
Rear Cross-Traffic Collision
Warning (RCCW) are not a
substitute for proper and safe
driving practices. Always
drive safely and use caution
when changing lanes or back-
ing up your vehicle.The Blind-
Spot Collision Warning sys-
tem (BCW) may not detect
every object alongside the
vehicle.
• The driver is responsible for
accurate brake control.
• Always pay extreme caution
whilst driving. The Rear
Cross-Traffic Collision
Warning System and Rear
Cross-Traffic Collision-
Avoidance Assist System may
not operate properly or
unnecessarily operate in
accordance with your driving
situations.
WARNING
• When the BCW system is
being activated, The warning
light on the outside rearview
mirror will illuminate whenev-
er a vehicle is detected at the
rear side by the system.
To avoid accidents, do not
focus only on the warning
light and neglect to see the
surrounding of the vehicle.
• Drive safely even though the
vehicle is equipped with a
BCW (Blind-Spot Collision
Warning) system. Do not sole-
ly rely on the system but
check for yourself before
changing lanes.
The system may not alert the
driver in some conditions so
always check the surround-
ings whilst driving.
(Continued)
OCD058024
To Next Page
