731
What to do in an emergency
9. Connect between compressor and
the vehicle power outlet using the
cable and connectors.
NOTICE
Only use the front passenger side
power outlet.
10. With the ignition switched on or
engine start/stop button position
on: Switch on the compressor
and let it run for approximately 3
minutes to fill the sealant. The
inflation pressure of the tyre after
filling is unimportant.
11. Switch off the compressor.
12. Detach the hose from the sealant
bottle connector and from the
tyre valve.
Return the Tyre Mobility Kit to its
storage location in the vehicle.
Distributing the sealant
13. Immediately drive approximately
7~10km (4~6miles or, about
10min) to evenly distribute the
sealant in the tyre.
OCD068006R
WARNING
Carbon monoxide poisoning
and suffocation is possible if
the engine is left running in a
poorly ventilated or unventilat-
ed location (such as inside a
building).
To Next Page
Loading...
