1-4Setup PAS SERIES
• Do not use the AC power cord provided with the product as a AC
power cord f
or other instruments.
• The power cord with a plug can be used to disconnect the PAS
series from the AC po
wer line in an emergency. Connect the plug to
an easily accessible power outlet so that the plug can be removed
from the outlet at any time.
• Secure adequate space around the po
wer plug
. Do not insert the
power plug to an outlet where accessibility to the plug is poor. And,
do not place objects near the outlet that would result in poor acces-
sibility to the plug.
Connection procedure
1. Check that the supply voltage is within the line voltage
ra
nge of the power supply.
Input voltage range: 100 VAC to 240 VAC
Frequency range: 50 Hz to 60 Hz
2. Turn OFF the POWER switch.
3. Connect the AC power cord to the AC INPUT connector on
the rear panel.
Use the provided power code or power code that is selected by qualified
personnel.
4. Plug in the AC power cord.
To Next Page
Loading...
