3-18 Basic Operation PAS SERIES
3.4 Switching the Power Display
The PAS series power supply allow you to vary the output voltage or
output current while checking the output power.
When varying the output voltage while checking the power
If you press the SHIFT+CURRENT switch (press the CURRENT
swit
ch while p
ressing the SHIFT switch) when the OUTPUT is on,
the current display shows the output power.
The LED to the right of the unit lights up when power is being dis-
played.
In this condition, select Coarse or Fine using the VOLTAGE switch
and vary the voltage using the dial.
To clear the power display, press the SHIFT+CURRENT (or SET)
switch again.
When varying the output current while checking the power
If you press the SHIFT+VOLTAGE switch (press the VOLTAGE
swit
ch while p
ressing the SHIFT switch), the voltage display shows
the output power.
The LED to the right of the unit lights up when power is being dis-
played.
In this condition, select Coarse or Fine using the CURRENT switch
and vary the voltage using the dial.
To clear the power display, press the SHIFT+VOLTAGE (or SET)
switch again.
Switching the display position
Once the power is displayed, you can switch the power display posi-
ti
on using
the VOLTAGE or CURRENT switch.
To Next Page
Loading...
