TOS5200 29
3
Safety Precautions for
Remote Control Precautions
When you are controlling the TOS5200 remotely, external signals are used to turn the high
voltage on and off. To prevent accidents, follow the safety measures given below.
● Make sure that high voltages are not generated unintentionally.
● Make it impossible to touch the DUT, test leads, test probes, and the areas near the
output terminals when high voltages are being generated.
Interrupting Testing or Operations
Before you change test conditions or other settings, press the STOP switch, and then be sure
to check the following items to ensure safety. If you will not use the product for some time or if
the operator will be away from the product, be sure to turn the POWER switch off.
● The TEST and DANGER LEDs are both off.
Emergency Measures
There are two actions that you must carry out if, due to a malfunction in the product or the
DUT, there is a possibility of an emergency occurring such as electric shock or damage to the
DUT.
● Turn the POWER switch off.
● Remove the power cord plug from the outlet.
STOP
START
Remove the power plug
from the outlet.
Turn the POWER switch off.
To Next Page
