E3 4K HDMI/3G-SDI Encoder User Manual
11
Copyright@2023 KILOVIEW Electronics Co., LTD
6 Login and Network Configuration
6.1 Device Login
1. Network Settings for your PC
Connect the computer to the network where the E3 is located, and check that the
network communication between the E3 and the computer is reachable. Users can
use the CMD tool that comes with the window to test.
2. WEB management page login
Open the browser on the computer, enter the IP address obtained by E3 in the
browser URL, and enter the username and password in the login dialog box.
Both default username and password are admin.
Note: Due to the browser compatibility issues, it may cause the web page display abnormal, it
is recommended to use Chrome or Edge.
6.2 Network Configuration
6.2.1 Ethernet
After login, you could configure internet IP by DHCP or manually (Default is DHCP).
This IP address could be used for network streaming and device management. Once
IP address configured, you could directly visit this IP address to login to the device.
To Next Page
Loading...
Need help?
General
