To Next Page

To Previous Page

E3 4K HDMI/3G-SDI Encoder User Manual

8.7 TS-UDP Streaming (Unicast and Multicast)

Click “＋” to add a stream service and selects “TS-UDP” as type.

The TS-UDP includes two ways: unicast and multicast. If use unicast, the "Target

Address" is the IP address of the device that receives the TS stream, and the "Target

Port" is a port that not conflict with the ports of other services, and the "Multicast

TTL" does not need to be modified. Unicast can only be decoded and played at the

target address. If use multicast, fill a correct multicast address (address range:

224.xxx ~ 239.xxx) in the "Target Address". "Target Port" is a port that not conflict

with the ports of other services. For other parameters, if there is no special

requirement, it is recommended to use the default.

Note: Multicast can only be decoded and played within the same network segment. Both

the encoder and the player need to configure a gateway to decode and play multicast normally.

After the setting is complete, a URL address will be generated in the TS-UDP push bar,

which can be decoded and played by decoding devices such as VLC. If the multicast is

decoded and played on the computer, the computer needs to close the firewall, and

the network needs to configure the gateway.

Kiloview E3 User Manual

Other manuals for Kiloview E3