King gates ROLLS - Programming Courtesy Light Button; Deleting All Memorized Transmitters; Deleting a Single Transmitter; Remote (Tools-Free) Transmitter Programming

41
EN
5.3 - Programming of the button linked
to the on-board courtesy light
This procedure allows for programming the button of the radio con-
trol linked to the on-board led courtesy light.
STEP ACTION RESULT
1
PRESS THE RADIO
BUTTON FOR 1 SECOND
The red
"radio" LED turns
on in the xed mode
2
PRESS THE SET BUTTON
FOR 1 SECOND
The red "radio" LED
remains lit and the
yellow "set" LED
turns on in xed
mode
3
PRESS THE DESIRED
BUTTON OF ALL THE
TRANSMITTERS TO BE
PROGRAMMED
The red "radio"
LED ashes and the
yellow "set" LED
remains lit in xed
mode
4
PRESS THE RADIO
BUTTON UNTIL THE
RADIO LED TURNS
OFF OR WAIT 20
SECONDS TO EXIT THE
PROCEDURE
The red "radio" LED
and the yellow "set"
LED turn off
5.4 - Deleting all memorised
transmitters
This operation deletes all memorized transmitters from the memory.
STEP ACTION RESULT
1
PRESS THE RADIO
BUTTON FOR 4
SECONDS AND RELEASE
IT WHEN THE RADIO LED
STARTS FLASHING
The red "radio” LED
ashes (if not, refer to
Paragraph 14.1)
2
PRESS THE RADIO
BUTTON FOR 1 SECOND
The red "radio” LED
ashes quickly to
signal the deletion in
progress
3
WAIT FOR THE END OF
THE PROCEDURE
The red "radio” LED
turns off
5.5 - Deleting a single transmitter
This operation deletes a single transmitter from the memory.
STEP ACTION RESULT
1
PRESS THE RADIO
BUTTON FOR 4
SECONDS AND RELEASE
IT WHEN THE RADIO LED
STARTS FLASHING
The red "radio” LED
ashes (if not, refer to
Paragraph 14.1)
2
PRESS THE SET BUTTON
FOR 1 SECOND
The red “radio” LED
ashes and the yellow
“set” LED turns on in xed
mode
3
PRESS A BUTTON ON
THE TRANSMITTER YOU
WISH TO CANCEL
The red “radio” LED
ashes and the yellow
“set” LED ashes
4
PRESS THE RADIO
BUTTON UNTIL THE
RADIO LED TURNS
OFF OR WAIT 20
SECONDS TO EXIT THE
PROCEDURE
The red “radio” LED and
the yellow “set” LED turn
off
5.6 - Remote (tools free) transmitter
programming
This procedure enables you to program a new transmitter (“Stylo2K”
or “Stylo4K”) without accessing the control unit, but keeping close
to it.
To run the procedure you will require a previously programmed trans-
mitter, to inherite its functions.
ON A PREVIOUSLY
PROGRAMMED TRANSMITTER,
HOLD DOWN BUTTONS 1 AND
2 TOGETHER FOR 4 SECONDS
ON THE TRANSMITTER YOU
WANT TO PROGRAM, HOLD
DOWN BUTTONS 1 AND 2
TOGETHER FOR 4 SECONDS