30
EN
1. General warnings
1.1 - Safety warnings
WARNING!
This manual contains important instructions
and warnings for personal safety.
An incorrect installation can cause serious
injury. Before starting work it is necessary
to carefully read all the parts of the manual.
If in doubt, suspend the installation and re-
quest clarication from the King-Gates Sup-
port Service.
WARNING!
According to the most recent European
legislation, the implementation of an
automation system must comply with
the harmonised standards set forth in the
Machinery Directive in force, which allow
for declaring the presumed conformity
of the automation. On account of this, all
operations regarding connection to the
mains electricity, as well as product testing,
commissioning and maintenance, must be
performed exclusively by a qualified and
skilled
technician!
WARNING!
Important instructions: keep this manual for
the possible future maintenance and dis-
posal of the product.
1.2 - Installation warnings
• Before beginning the installation procedure,
check that this product is suitable for the intend-
ed use (see sections 3.1 and 3.2). If it is not suit-
able, DO NOT proceed with the installation.
The contents of this manual refer to an installa-
tion like the one shown in g. 1.
• Taking into account the hazards which could
occur during installation and product operation,
the automation system should be installed ac-
cording to the following procedure:
- Ensure there is a system device which is a
means of disconnection from the supply mains.
This device must have a contact separation in
all poles which ensures full disconnection under
overvoltage category III conditions.
- All installation and maintenance operations
must be carried out with the automation system
switched off and the power supply disconnected.
If the disconnection device is not visible from
where the automation system has been installed,
a sign must be attached to it before attempting
any work. The sign should read:
“CAUTION! MAINTENANCE IN PROGRESS".
- The product must be connected to a power
supply line equipped with safety grounding sys-
tem.
- Take care not to crush, bang, drop or spill any
kind of liquid on the automation system during
installation. Do not place the product near heat
sources or expose it to open ames. All these
actions can damage it and cause malfunctions
or dangerous situations. If this were to happen,
stop installation immediately and contact KING-
gates Customer Service.
- Do not make alterations to the product in any
way. Unauthorized tampering can only cause
malfunctions. The manufacturer declines all li-
ability for any damages deriving from arbitrary
changes to the product.
- This product is not intended for use by people
To Next Page
Loading...
