King gates ROLLS - 18 CE Declaration of Conformity

54
EN
18. EU Declaration of Conformity and declaration of
incorporation of “partly completed machinery”
Document N. 1111
Language English (translated from Italian)
Revision 1
Manufacturer’s Name: KING GATES S.r.l.
Address: Via Malignani, 42 - 33077 - Sacile (PN) Italy
Authorized Person to constitute the technical documentation: KING GATES S.r.l.
Address: Via Malignani, 42 - 33077 - Sacile (PN) Italy
Type of product: Electromechanical gearmotor for sectional doors with
control unit and receiver
Model/Type: ROLLS 700 NG
ROLLS 1200 NG
Accessories: refer to the catalog
The undersigned, Giorgio Zanutto, in the role of Chief Executive Ocer, declares under his sole responsibility, that the product specied
above conforms to the provisions of the following directives:
• Directive 2014/53/UE (RED)
· Health protection standards (art. 3(1)(a)): EN 62479:2010
· Electrical safety (art. 3(1)(a)): EN 60950-1:2006 + A11:2009 + A12:2011 + A1:2010 + A2:2013
· Electromagnetic compatibility (art. 3(1)(b)): EN 301 489-1 V2.2.0:2017, EN 301 489-3 V2.1.1:2017
· Radio spectrum (art. 3(2)): EN 300 220-2 V3.1.1:2017
The product also complies with the following directives according to the requirements envisaged for “partly completed machinery” (Annex
II, part 1, section B):
Directive 2006/42/EC OF THE EUROPEAN PARLIAMENT AND COUNCIL of 17 May 2006 related to machinery, and which amends the
directive 95/16/EC (recast).
• It is hereby declared that the pertinent technical documentation has been compiled in compliance with appendix VII B of directive
2006/42/EC and that the following essential requirements have been observed:
1.1.1- 1.1.2- 1.1.3- 1.2.1-1.2.6- 1.5.1-1.5.2- 1.5.5- 1.5.6- 1.5.7- 1.5.8- 1.5.10- 1.5.11
• The manufacturer undertakes to transmit to the national authorities, in response to a motivated request, all information regarding the
“partly completed machinery”, while maintaining full rights to the related intellectual property.
• Should the “partly completed machinery” be put into service in a European country with an ocial language other than that used in this
declaration, the importer is obliged to arrange for the relative translation to accompany this declaration.
• The “partly completed machinery” must not be used until the nal machine in which it is incorporated is in turn declared as compliant, if
applicable, with the provisions of directive 2006/42/EC.
The product also complies with the following standards:
EN 60335-1:2012+A11:2014, EN 62233:2008
EN 60335-2-95:2015+A1:2015
EN 61000-6-2:2005, EN 61000-6-3:2007+A1:2011
Place and Date: Sacile 20/09/2018
Giorgio Zanutto
(Chief Executive Ocer)