King-Meter KM6S-LCD - Password Setting; Password Enable

KING-METER TECHNOLOGY CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134, CN
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378
- 13 -
5.12 Password Setting
Hold UP and DOWN buttons simultaneously for 2 seconds to enter the general
setting state; then hold UP and MODE buttons simultaneously for 2 seconds to
enter the power-on password setting state.
The display prompts “PASSWORD 2”, indicating that you need to enter the
power-on password. Press the MODE button to shift, and increase/decrease the
input value by UP/DOWN. After the 4-digit password is entered, press the MODE
button to confirm. If the password is correct, enter the power-on password user
setting interface, otherwise it will stay in the password input state. Hold MODE
button to exit. The factory default is: 1234.
Password input
5.12.1 Password Enable
Select Y/N through UP/DOWN, Y means power-on password is required, and
N means power-on password is not required. Shortly press MODE to confirm and
enter the display password modification interface.