KING-METER TECHNOLOGY CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134, CN
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378
5.14.7 Throttle Function Setting
5.14.7.1 Throttle Walk Assist Enable Setting
HL indicates the throttle’s walk assist function. HL: N means that the throttle does
not has this function, and HL: Y means that throttle has this function, that is, when
turning the throttle, the display enters the walk assist mode. Y/N can be switched
by UP/DOWN. If you select N, press MODE shortly to confirm and enter the
throttle level enable setting interface, otherwise there is no response. Hold MODE
to confirm and return to the display’s personalized parameter setting interface.
The factory default value of the display is N.
Throttle walk assist enable setting
5.14.7.2 Throttle Level Enable Setting
HF indicates the throttle level setting. HF: N means that the throttle doesn’t split
levels according to the PAS ratio. If the throttle level splitting is enabled, the
maximum output of the motor can only reach the speed of the corresponding PAS
level shown on the display when turning the throttle; if no level splitting, it means
that when the throttle is turned, the speed will not limited to the PAS level shown
on the display, it can reach to the rated maximum speed. Y/N can be set by
UP/DOWN. Hold MODE to confirm and return to the display’s personalized
parameter setting interface. The factory default value of the display is N.
To Next Page
Loading...
Need help?
General
