KING-METER TECHNOLOGY CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134, CN
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378
Change the maximum current value of the controller by UP/DOWN. Hold MODE to
confirm and return to the personalized parameter setting interface. The factory
default value of the display is 15A.
Current limit setting
Depending on the hardware of the controller, the controller may not be able
to reach the set 18A.
5.14.5 PAS Sensor Setting
5.14.5.1PAS Sensor Direction Setting
run indicates the PAS sensor direction setting. The display shows run.F/b. run.F
stands for forward and run.b stands for reverse. Switch by UP/DOWN. Press
MODE to confirm and enter the PAS sensor sensitivity setting. The factory default
value of the sensor direction is positive.
To Next Page
Loading...
