3) Select “Stun/Un-stunned”.
4) Enter “Contact List” and select the target private call contact.
The screen shows the alias or ID of the target radio and the radio indicates that it is sending stun/un-stun
signaling. The red indicator glows.
5) Waiting for response from the target radio.
If the response from the target radio is received, the screen will show “Stun Succeeded”/“Un-stun
Succeeded”, or it shows “Stun Failed”/“Un-stun Failed”.
Note:
If you press in the process of sending signaling, the radio will stop sending stun/un-stun signaling.
If the retry count is used up and no response is received, the radio will automatically stop sending
signaling and indicate that the transmission failed.
10.4 Radio Kill
Kill feature allows the user to kill the target radio through air signaling. After the target radio is killed, the key
configuration data will be cleared and the radio is powered off automatically. You cannot operate the radio
after powering it on.
The killed radio can only be revived by the authorized dealer or supplier.
This feature is used to prevent the lost radio from being used and the key configuration data from being
stolen.
To Next Page
Loading...
Need help?
General
