KMC Controls FlexStat User Manual

FlexStat 41 Operation Guide, Rev. R
Reference
Commonacronymsandabbreviations in FlexStat
and related documents include:
amp = amperes
A = amperes
AAC = Advanced Application Controller
A/C = air conditioning
AC = alternating current
AHU = air handling unit
AI = analog input
avg. = average
AWG = American Wire Gauge
BACnet = Building Automation Control network
BTL = BACnet Testing Laboratories
C = Celsius
c = cubic feet per hour
cfm = cubic feet per minute
cm = centimeters
DA = direct acting
DAT = discharge air temperature
DST = Daylight Saving Time
DC = direct current
DCV = Demand Control (or Controlled) Ventilation
DPDT = double pole double throw
DPST = double pole single throw
EIA = Electronic Industries Alliance
EOL = end of line
F = Fahrenheit
FCU = fan coil unit
FIU = fan induction unit
FST = fan status
ft-lbs. = foot pounds
g = grams
HPU = heat pump unit
HVAC = heating ventilating and air conditioning
Hz = her
IP = Internet protocol
LAT = leaving air temperature (same as DAT)
LCD = liquid crystal display
mA = milliamperes
MAC = media access control
MAT = mixed air temperature
max. = maximum
min. = minimum
mm = millimeters
MS/TP = master-slave/token-passing
NC = normally closed
NO = normally open
OAT = outside air temperature
pF = picofarad
RA = reverse acting
RH = relative humidity
RS = Recommended Standard
RTC = real time clock
RTU = roof top unit
SAT = supply air temperature
SPDT = single pole double throw
SPST = single pole single throw
UL = Underwriters Laboratories
USB = universal serial bus
UTC = Coordinated Universal Time
V = volts
VA = volt-ampere
VAC = volts alternating current
VAV = variable air volume
VDC = volts direct current
W = was
Acronyms and Abbreviations
NOTE: See also the Denitions of Terms on page 42.

KMC Controls FlexStat Specifications

General

Brand	KMC Controls
Model	FlexStat
Category	Thermostat
Language	English