KNECHT E 50 - Servicing (Maintenance, Repair) and Fault Rectification; Structural Alterations to the Sharpening Machine; Cleaning the Sharpening Machine; Oils and Greases

15
2.4.9 Servicing (maintenance, repair) and fault rectification
Maintenance work is to be carried out on schedule by trained personnel. Inform operating
personnel before starting repair work. The responsible supervisor is to be named. For all service
work, the sharpening machine is to be disconnected from the power supply and secured against
accidental restarting. Pull out the mains plug. Cordon off the servicing area, as far as possible.
After completion of the maintenance work and fault rectification, install all the safety devices and
check whether they are fully functional.
2.4.10 Structural alterations to the sharpening machine
Modifications, retrofitting or rebuilds of the sharpening machine are not allowed without the per-
mission of the manufacturer. This also applies to the installation and adjustment of safety devices.
No alterations may be carried out without prior written permission from KNECHT Maschinenbau
GmbH.
Immediately replace machine parts which are not in perfect condition.
Use only original replacement and wear parts. If parts are purchased from external suppliers, it
cannot be guaranteed that they will be constructed and manufactured to withstand the stresses
and provide the level of safety required for operating the sharpening machine.
2.4.11 Cleaning the sharpening machine
Cleaning agents and materials used must be handled properly and disposed of in an environ-
mentally friendly way.
Ensure that wear and replacement parts are disposed of in a safe and environmentally friendly
way.
2.4.12 Oils and greases
When handling oils and greases, follow the safety instructions for the product. Observe special
instructions for the food industry.
2.4.13 Relocation of the sharpening machine
Even when moving the machine a short distance from its site, disconnect it from all external
power supply sources. Before restarting the machine, connect it properly to the current supply.
When loading or unloading, only use hoisting and load lifting equipment with sufficient
load-bearing capacity. Appoint a qualified banksman (signaller) for the lifting process.
No persons other than those entrusted with this work may be present in the loading and
installation area.
2. Safety