KNECHT E 50 - Maintenance Plan

49
9. Care and maintenance
9.3 Maintenance Plan
Interval Component assembly Maintenance activity
Daily Polishing paste Check paste length. Replace if below 80 mm.
Polishing / deburring units Adjust the spacing between brushes. Replace if
diameter below 165 mm.
Knife magazine Remove and clean the knife magazine.
Interior of the machine Clean coarse impurities with scrubber.
Coolant unit Empty water, clean basin.
Weekly Grinding belt drive Open belt protecting hood and clean the area of
the grinding belt.
Suction unit Empty suction unit tray.
Polishing / deburring units Check the brush diameter. Replace if diameter
below 165 mm.
Machine
interior and exterior
Clean machine interior and exterior. Attention!
The polishing / deburring brushes must not get wet.
Monthly Grinding belt drive Remove and clean flow gauges.
Suction unit Check filter cartridge and remove, clean or replace
as needed.
Annually Request service call from KNECHT Maschinenbau
GmbH