44
9. Care and maintenance
Figure 9-1 Central lubrication system
9.1 Lubrication
The machine is equipped with a central lubrica-
tion system which regularly lubricates the guides.
When the message: “Refill lubricant in central
lubrication unit” (16) appears, refill the oil in the
container (9-1/1) immediately.
If the container is empty, air enters the lubricant
lines. Consequently, the guides are not supplied
with oil.
Press the touch panel button “F8 Settings” (3-
6/21), then “F4 Reset gripper cycles” (8-11/2), to
reset the message.
ATTENTION
The container for the central lubrication unit
must never be allowed to be empty.
When the message “Check gripper oil level
(17)” appears, check the oil level in the con-
tainer (9-1/1) and refill as necessary.
Remove the contact disk of the wet-grinding belt
every month and press grease into the lubrication
point until grease oozes out of the hole below the
motor shaft.
Furthermore, lubricate the safety doors every
month with the grease gun provided along with
the machine. Two lubrication points each are
located on each side of the door. Raise the safety
doors until the lubrication points in the holes are
visible.
1
To Next Page
Loading...