46
9. Care and maintenance
9.2 Cleaning
Clean the machine each time after sharpening
to prevent the swarf from drying, which makes it
harder to remove.
After cleaning, lightly grease the sharpening ma-
chine with non-corrosive oil. See also Lubrication
Schedule in Chapter 9.1.1.
Replace coolant daily and clean container.
Press the “Coolant On” button (9-2/1) and clean
the inside of the machine using the scrubber (3-
3/9).
ATTENTION
Polishing and deburring brushes must not get
wet, since they can only absorb polishing
paste and can only correctly deburr a knife in
dry state.
The parts of the cross-table must not get wet.
Never spray the machine with a high-pres-
sure jet cleaner.
Empty the tray of the suction unit (9-3/1) once per
week.
Figure 9-2 Control panel
1
Figure 9-3 Suction unit tray
1
To Next Page
Loading...