34
7. Operation
7.4 Adjusting the polishing / deburring brushes
The polishing / deburring brushes must be adjusted
so that the foremost brush touches the flange of
the adjacent brush in each case.
The adjustment is carried out using the SW5 hex
wrench provided with the accessories. Replace
polishing / deburring brushes at Ø 165 mm.
ATTENTION
Use only original polishing and deburring
brushes.
Using non-original polishing and deburr-
ing brushes can cause damage to knife and
machine.
Figure 7-6 Adjusting the polishing / deburring
brushes
To Next Page
Loading...