23
18 “F5 Magazine 1 changed”: 1x tapping moves the magazine back by one knife. Tapping
and holding for 2 seconds resets the magazine completely.
19 “F6 Reset” Resets the control unit
20 “F7 Belt Reset”: Deletes the “Change grinding belt” message (press and hold for 2 sec.)
21 “F8 Settings”: Switches to the “Settings” menu
22 “F9 Magazine 2 changed”: 1x tapping moves the magazine back by one knife. Tapping
and holding for 2 seconds resets the magazine completely.
23 “F10 Abort Program”: The current program is aborted and the grinding program is
started all over again
24 “F11 Product data”: To load different grinding programs (for loaded product file,
see (3-6/2))
25 “F12 Back”: Goes back to the previous screen or closes the user interface
NOTICE
When the key switch (3-4/6) is on position
“1”, the knife gripper arm (3-3/1) can be
activated even when the door is open.
Touch panel buttons “F1 Polishing paste 1
pulse” (3-6/14) and “F2 Polishing paste 2
pulse” (3-6/15) function only in automatic
mode while the polishing units are active.
Pulling out the knife magazine resets the
machine.
3. Description
To Next Page
Loading...