4-98 A-61635 December 2010
Fixed field value — specifies the default value for the Fixed field portion of the
image address. You can either type in the Fixed field value (enclosed in double
quotes “”) or select Setup to access the Fixed Field Value Configuration dialog
box.
The left side of the dialog box contains a list of pre-defined values that you can
use to build the Fixed Field formula. The Fixed field value can consist of one or
more pre-defined values as specified in the formula. The total number of
characters in the formula cannot exceed the defined length for the Fixed field.
To set up a Fixed field formula:
1. Select a pre-defined value from the list box.
2. Click Add Item.
3. Repeat Steps 1 and 2 until the formula is complete.
Select Delete Item to delete the last pre-defined value that was added. Delete
Formula deletes the entire Fixed field formula. You can also use a special
substring syntax, enclosed within square brackets, to retain a certain portion of
a pre-defined value (e.g., [1,4]).
To Next Page
Loading...