4-16 A-61635 December 2010
Use the Default Value Setup dialog box to create or revise a formula for the
default value of the index field.
• Select a predefined value from the Predefined Values list. The Default
Value Formula (if any) will be displayed on the right side of the box.
• Click Add Item.
NOTE: Delete Item removes the last predefined value that was added
to the Default Value Formula; Delete Formula removes the
entire Default Value Formula.
• Click OK when finished. The revised formula will be populated into the
Default Value text box.
14. Enter your input format. See the section entitled “Input formats” later in this
chapter for more information.
15. Enter your output format. See the section entitled “Output formats” later in
this chapter for more information.
16. If you want to define Substitute Characters, click Setup to define
character pairs for automatic substitution. The Substitute Characters Setup
dialog box will be displayed.
• Original column — lists the old characters to be replaced. Select an
original character from the drop-down list at the bottom of the column.
Select <Space>, <Linefeed> or <Tab>. An original character can appear
only once in the Original column.
• Substitute column — lists the new characters to be put in. Select a
substitute character from the drop-down list at the bottom of the column.
Select <Space>, <Linefeed>, <Tab> or <Replace>. A substitute
character may appear more than once in the Substitute column.
• Add — click to add the original and substitute character pair that you
selected from the two drop-down lists. If you only selected an original
character, Kodak Capture Pro Software will default to <Replace> as the
substitute character.
• Delete — deletes the highlighted original and substitute character pair
from the Original and Substitute columns.
To Next Page
Loading...