Kodak EASYSHARE C140

SERVICE MANUAL
42 15APR10 – SM8720-1
MAIN BOARD: Memory - “Reset”
Adjustment Specification
Caution
Dangerous Voltage
Prerequisites:
None
To Check:
You cannot check this adjustment.
To Adjust:
[1] Do “Preparing the “C140 Reset” MEMORY CARD” on Page 64.
[2] Insert into the CAMERA:
• BATTERIES with a full charge
• “C140 Reset” MEMORY CARD
[3] Energize the CAMERA.
[4] If the LCD displays “Set Date & Time”, select “Cancel”.
[5] Check that “Script Loading...” displays on the LCD.
Note
When the images are loaded and test is completed, the CAMERA de-energizes automatically.
[6] Remove from the CAMERA:
• MEMORY CARD
• BATTERIES
[7] Install the BATTERIES into the CAMERA again.
[8] Energize the CAMERA.
Purpose: To set the values to the defaults.
Do When: • After installing a new LCD.
• Doing a reset might initialize the correct operation of the CAMERA.
Specification: The settings are reset to the defaults.
Special Tools: • Computer with a MEMORY CARD READER/WRITER
• BATTERIES with a full charge
• MEMORY CARD