Support
Print Spotted
Probable Cause
Paper may be dirty.
Corrective Action
Use a dry, lint-free cloth to wipe clean. For excessive dirt or debris, thoroughly clean the paper tray,
and load new paper.
Note Keep paper tray covers closed to keep dust and debris from collecting on the paper or inside
the printer.
Print Too Dark
• Try retaking the picture with the flash on, or move within the flash range of the camera. Refer to
your camera user’s guide for details.
• Adjust the exposure compensation on your camera, and try taking the picture again. Refer to
your camera user’s guide for details.
• Edit the picture using Kodak Home Center or other image editing software.
• Make sure the printer is not placed in direct sunlight or is not operating in a high-temperature
environment.
Print Too Light
Important For best results, use Kodak ink cartridges and paper for your printer.
• Make sure the paper is loaded with the Kodak logo facing up. Reload if necessary.
• Try taking the picture again with the flash off. Refer to your camera user’s guide for details.
• Adjust the exposure compensation on your camera, and try taking the picture again. Refer to
your camera user’s guide for details.
• Edit the picture using Kodak Home Center or Kodak EasyShare software on your computer.
Refer to the Home Center or EasyShare software Help for details.
Printing Slow
Note When printing a large number of prints, printing may slow down to prevent the printhead
from overheating.
• Make sure the printer is not placed in direct sunlight or is not operating in a high-temperature
environment (higher than 95° F, or 35° C).
• Close unnecessary software applications.
• Make sure your computer meets the minimum system requirements. Upgrade your system if
necessary
User Guide 53
To Next Page
Loading...
